Znaleziono w kategoriach:
Smartwatche (5)
Wróć
User Manual
ROUND
WATCH
GSM
MT855
2
EN Introduction
Thank you for buying media-
tech smartwatch GSM. Device
supports smartphones with
Android 4.2.2 or higher oper-
ating system. In order to use all
smartwatch functions please
download free application
“FunRun” using QRcode scan
or download manually from
www.media-tech.eu website.
3
EN
Overview
LCD with
touch panel
Battery status
Home button
nanoSIM
card slot
microSD
card slot
Microphone
USB socket
(for charging)
Installation steps
1. Remove battery cover
4
EN 2. Install nanoSIM card (it is not necessary, smartwatch can still make
phone calls via Bluetooth). Slide hatch, open up, put nanoSIM card,
close, slide again to lock.
3. Install microSD card – slide microSD card into slot (it is not necessary).
4. Install rechargeable battery.
5. Put back battery cover.
Charging
Use USB cable and plug into USB charger or USB port in PC computer.
During charging battery icon will animate. After ca. 2 hours battery is full,
battery icon animation is stopped.
Note! We recommend to perform at rst three full charging cycle in order to
format built-in battery. If device is not used for longer timer please charge it
once a week at least.
Power on/o
Press and hold home button for 3 seconds to power on the device , repeat
this action to pop-up question, conrm to power o the device. When
5
EN
device is in standby mode press once home button to switch analog clock
view, press again to turn o LCD. When LCD is o press and hold home
button for 1 sec to resume screen.
Analog clock view
Click in the middle of screen to change analog clock type.
First steps
1. Fully charge device before rst use.
2. Power on the smartwatch and go to the Bluetooth section. Enable
searching for Bluetooth devices.
3. Enable Bluetooth interface in your smartphone and enable visibility for
unpaired devices.
4. Use smartwatch and select your smartphone on the list.
5. On both devices you should see the same passcode. Click OK on both
devices to pair successful.
6. Now install “FunRun” application on your smartphone. Display QRcode
on the smartwatch (go to “menu/QuickResp” and use your smartphone
to scan this code, next open scanned link, your web browser will auto-
matically download installation le.
7. Wait until application is downloaded and open it to perform installa-
tion process.
8. Run application and allow application to freely communicate with
smartwatch.
9.
Use smartphone and go to menu/accessibility settings/FunRun – enable.
10. Power o and power on smartwatch – now you can use smartwatch.