Znaleziono w kategoriach:
RUS
RO
UA
AR
FR
PL
ES
PT
EN
ELEKTRYCZNY PRZEPŁYWOWY OGRZEWACZ WODY
CHAUFFE-EAU ÉLECTRIQUE INSTANTANÉ
CALENTADOR DE AGUA ELÉCTRICO INSTANTÁNEO
AQUECEDOR INSTANTÂNEO DE ÁGUA ELÉTRICO
يروف يئابرهك هايم ناخس
ПРОТОЧНИЙ ЕЛЕКТР ИЧН ИЙ ВОДОН АГРІВАЧ
ПРОТОЧНЫЙ ЭЛЕКТРИЧЕСКИЙ ВОДОНАГРЕВАТЕЛЬ
ÎNCĂLZITOR DE APĂ ELECTRIC INSTANT
INSTANTANEOUS ELECTRIC WATER HEATER
2
EN
GENERAL SAFETY INSTRUCTION
1. This manual is an integral part of the product. Keep it with care with the appliance, and hand
it on to the next user/owner in case of change of property.
2. Read the instructions and warning in this manual carefully, they contain important informa-
tion regarding safe installation, use and maintenance.
3. The appliance must be installed and commissioned by a qualified technician in accordance
with local legislation and health and safety regulations. All power circuits must be shut off
before you open the terminal block.
4. DO NOT use the appliance for any other than its specified use. The manufacturer is not liable
for damage resulting from improper or incorrect use or failure to observe the instructions
given in this manual.
5. Incorrect installation can result in damage to property and injury to persons and animals; the
manufacturer is not liable for the consquences.
6. DO NOT leave the packaging materials (staples, plastic bags, expanded polystyrene, etc.)
within the reach of children - they can cause serious injury.
7. This appliance can be used by children aged from 3 years and above and persons
with reduced physical,sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision orinstruction concerning use of the
appliance in a safe way and understand the hazards involved. DO NOT permit chil-
dren to play with the appliance. User cleaning and maintenance may not be done by
unsupervised children.
8. Any repairs, maintenance, plumbing and electrical hookup must be done by qualified tech-
nicians using original spare parts only. Failure to observe the above instructions can compro-
mise the safety of the appliance and relieves the manufacturer of any liability for the conse-
quences.
9. The hot water temperature is regulated by a thermostat which also acts as a safety device to
prevent dangerous overheating.
10. The electrical hookup must be done as indicated in this manual.
11. If the appliance is equipped with a power cord, the latter may only be replaced by an author-
ised service centre or professional technician.
12. Make sure to drain the appliance when it is out of service or in an area subject to subzero
temperatures.
13. Do not leave flammable materials in contact with or in the vicinity of the appliance.
14. DO NOT touch the appliance when barefoot or if any part of your body is wet
15. Before using the device and after routine or extraordinary maintenance, we recommend fill-
ing the appliance’s tank with water and draining it completely to remove any residual impuri-
ties.
16. Do not place anything under the water heater which may be damaged by a leak.
3
EN
Symbol Meaning
Failure to observe this warning can result in injury, which may even be fatal in certain circumstances
Failure to observe this warning can msult in damage or injury, even to property; plants and animals
Observe the product's general and specific safety instructions.
GENERAL SAFETY STANDARDS
Ref. Warning Risk Symbol
1.Do not open the appliance or remove from its
installation
Electrocution hazard due to the presence of live electrical
equipment. Personal injury -overheated burns caused by
components and wounds caused by sharp edges
2. Do not start or stop the appliance by inserting/
pulling the power plug
Electrocution hazard due to damage to the power cord,
its plug or the socket
3. Do not damage the power cord Electrocution hazard due to bare live wires
4. Do not leave objects on the appliance Personal injury due to objects falling off the appliance as
a result of vibration
Damage to the appliance or other property due to
objects falling off the appliance as a result of vibration
5. Do not climb onto the appliance Personal injury due to falling off the appliance
Damage to the appliance or other property due to the
appliance itself detaching from its mounting
6. Do not clean the appliance without having first
switched it off, pulled its power plug or shut off its
power switch
Electrocution hazard due to the presence of live electrical
equipment
7. Install the appliance to a solid wall which is not
subject to vibration
Danger of the appliance falling off the wall due to
structural collapse, or noisy operation
8. Make the electrical hookup with cables of
adequate cross-section
Danger of fire due to overheating of undersized electrical
wires
9. Restore all safety and control functions after
working on the appliance and check that they are
operational before returning it to service
Damage or blocking of the appliance due to improper
control
10. Drain all components containing hot water, using
the bleed cocks, before handling them
Danger of burns
11. Descale the system as given in the products
"safety sheet"; when doing so, ventilate the
room,wear safety clothing, make sure not to mix
products, and protect the appliance itself and any
adjacent objects
Personal injury due lo contact of the skin and eyes with
add, inhalation or ingestion of noxious chemicals
Damage to the appliance and adjacent objects due to
corrosion by acid
12. Do not use insecticides, solvents or aggressive
detergents to clean the appliance
Damage to plastic and painted parts and assemblies
4
EN
TECHNICAL CHARACTERISTICS
For the technical specifications, refer to the nameplate (the nameplate is located on the right side of the
water heater).
PRODUCT INFORMATION
Model
AURES M 5 EU AURES M 6
AURES M 6 EU
AURES M 7 EU
AURES M 7 EG
AURES M 7.7
AURES SM2 7.7 EU
AURES M 7 SASO KSA AURES M 8
Power (kW)
5-6 6-7.1 7-8.3 7.7-9.1 7.75 8-9.5
Voltage (V)
220-240 220-240 220-240 220-240 220-240 220-240
Phases
Mono
Installation
Multi point
Construction
Close outlet
Frequency (Hz)
50/60
Electric current (A)
25 29.6 34.6 37.9 33.7 39.6
Electrical diagram
I II II I II II
Water Protection
IP25
Pipe Connection
1/2" BSP
Minimum water flow (l/min)
2.1
Qelec (kWh)
2.119 2.119 2.224 -- -- --
Max water pressure
800 kPa (8 bar)
Load profile
XXS XXS XS -- -- --
Lwa (dB)
15
ηwh
40% 40% 38% -- -- --
Rated Volume (l)
0,45
Weight (kg)
2
Dimensions (mm)
304 x 180 x 110
The power consumption data in the table and the other information given in the Product Data Sheet
(Enclosure A to this manual) are defined in relation to EU Directives 812/2013 and 814/2013.
The products without the label and the data sheet for water heaters and solar devices, stipulated in regulation
812/2013, are not intended to be used in such assemblies.
Products equipped with a regulator knob have the thermostat positioned in the <ready to use setting
indicated in the Data Sheet (Enclosure A), according to which the relevant energy class has been declared
by the manufacturer.
The product should be connected only to a supply with the relevant system impedance no
more than 0.237 ohm.
Restrictions to connection may be imposed by the supply authority on the use of
equipment in the actual relevant system impedance at the interface point on the user's
premise exceeds 0.237 ohm.
This appliance is conforming with the international electrical safety standards IEC 60335-1
and IEC 60335-2-35. When present, The CE marking of the appliances attests its conformity
to the following EC Directives, of which it satises the essential requisites:
- LVD Low Voltage Directive: EN 60335-1, EN 60335-2-35, EN 60529, EN 62233, EN 50106.
- EMC Electro-Magnetic Compatibility: EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3,
EN 61000-3-11 and EN 61000-3-12.
- ERP Energy related Products: Eu812, Eu814, EN50193-1-2013
5
EN
Installation Instructions:
The appliance must be installed and commissioned by a qualified technician in accordance with established
regulations and local health and safety regulations..
248 mm
108 mm
102 mm
24 mm
140 mm
1.
2.
3. .
4. Use the supplied water lter on the inlet water pipe line (see diagram)
5. Connect the incoming water line (cold only) to the inlet water pipe on the bottom right side and the
outgoing water line to the outlet water pipe on the bottom left side. Open the mains cock of water
supply and check there is no water leakage from the unit.
6. Use a two-pole switch conforming with national laws in force (contact gap of at least 3 mm, preferably
equipped with fuses) to disconnect the appliance's power supply.
7. Connect the power cable to the terminal block inside the unit. The appliance must be earthed and the
earth cable must be fixed to the terminal marked by the symbol .
8. Turn on the unit and check that it is operating as required.
9. Reconnect the cover to the base with 2 screws.
10. It is required that a Ground Fault Circuit Interrupter/Earth Leakage Circuit Breaker be incorporated in the
circuit.
11. Make sure to install in the right way the pressure relief valve (supplied with the product)
before Inlet pipe.
12. It is required to install a ow control restrictor (AERATOR) at the sink or shower
.
13. WARNING: UNIT MUST BE PROPERLY GROUNDED
14. THIS HEATER MUST HAVE ITS OWN INDEPENDENT CIRCUIT USING A CORRECTLY RATED CIRCUIT
BREAKER AND SUITABLE WIRE, SEE TABLE RECOMMENDED CABLE.
1. Before performing any operations, disconnect the appliance from the electricity mains using the external
switch.
2. Open the two screws located at the bottom of the device and remove the cover from base.
3. Fix the base horizontally against a wall or side of cabinet, the inlet and outlet water pipes are on the
down/bottom side of the unit. Use the three mounting screws provided.
cable
Flow restrictor
AERATOR
Hot
water
out
Cold
water in
only
WARNING: If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualied persons in order to avoid a hazard.