Znaleziono w kategoriach:
Kamery cofania (2)
Wróć
KCA-R200
Rear Camera for Dashboard Camera
INSTRUCTION MANUAL
• Updated information (the latest Instruction Manual, etc.) is available from
<https://www.kenwood.com/cs/ce/>.
© 2019 JVCKENWOOD Corporation R200-V2.4.D.A-Multi
Register Online
Register your KENWOOD product at www.kenwood.com/usa
For your records
Record the serial number, found on the back of the unit in the spaces designated on the
warranty card, and in the space provided below. Refer to the model and serial numbers
whenever you can upon your KENWOOD dealer for information or service on the product.
Model KCA-R200
Serial Number______________
US Residents Only
English
Before Use…………………………………………………………………………………...
Precautions for Use…………………………………………………………………….......
Accessories …………………………………………………………………………………..
Parts Name …………………………………………………………………………………..
Installation and Connection ……………………………………………………………...
Specifications ………………………………………………………………………………..
01
01
03
03
04
08
Contents EN
01
Precautions and notices
Warning! Do not operate the device while driving. Using this product does not change the
requirement for a driver to take full responsibility for his or her behavior. This responsibility includes
observing all traffic rules and regulations in order to avoid accidents, personal injury or property
damage.
Caring for your device
Taking good care of your device will ensure trouble-free operation and reduce the risk of damage.
For your own safety, do not operate the controls of the product while driving.
Make sure to place your cable, so as not to obstruct the driver's view or deployment of airbags.
Do not attempt to service the unit. There are no serviceable parts inside. Replace the unit if it is
damaged or exposed to excess moisture.
Keep your device away from excessive moisture and extreme temperatures.
Avoid exposing your device to direct sunlight or strong ultraviolet light for extended periods of
time.
Do not place anything on top of your device or drop objects on your device.
Do not drop your device or subject it to severe shock.
Do not subject your device to sudden and severe temperature changes. This could cause moisture
condensation inside the unit, which could damage your device. In the event of moisture
condensation, allow the device to dry out completely before use.
Never clean your device with the power on. Use a soft, lint-free cloth to wipe the screen and the
exterior of your device.
Never attempt to disassemble, repair or make any modifications to your device. Disassembly,
modification or any attempt at repair could cause damage to your device and even bodily injury or
property damage and will void any warranty.
Do not store or carry flammable liquids, gases or explosive materials in the same compartment as
your device, its parts or accessories.
To discourage theft, do not leave the device and accessories in plain view in an unattended vehicle.
Overheating may damage the device.
Precautions for Use
•
•
•
•
•
•
•
•
•
•
•
•
•
Before Use
The screen images and operation examples in this document were created for explaining the
operating procedures.
There may be screen images that differ from the actual screens or examples of operations not
actually performed.
Please note that JVCKENWOOD shall not be responsible for any damages suffered by the
customer or a third party as a result of incorrectly using this product, a failure during use of
this product, or other trouble, or due to the use of this product, unless such liability is
acknowledged by law.
Recorded video, image, and audio content cannot be used for other than personal enjoyment
without the consent of the copyright holder as specified in the Copyright Act.
Please note that the recording of an event such as a show, performance, or exhibition may be
restricted even when doing so for personal enjoyment.
•
•
•
•
•
Disclaimer
Copyrights
02
Install the device in a position where it will not block the view of the driver.
Install the device within the wiping range if equipped the wiper.
Take care not to install the device over the vehicle inspection sticker or other sticker.
Take care not to install the device where it will interfere with driving or airbag operation.
If the device is installed incorrectly, event recording or parked recording may not work correctly.
Refer to “Installation and Connection” for the installation orientation, angle, and other
information and then install the device correctly.
Do not install the device near a digital terrestrial television antenna or an electrical component.
Otherwise it may reduce receiver sensitivity or cause flickering and noise.
When fixing the device with the adhesive mount, use a commercially available cleaning cloth or
the like to wipe off all dirt and grease on the mounting surface. If the device is re-affixed or
mounted using, for example, general-purpose double-sided tape, the adhesion strength may
weaken and cause the device to fall.
After mounting the device, leave it for 24 hours before use to enable the mounting strength of
the adhesive mount to improve. Failing to do so may result in the adhesion of the adhesive mount
becoming weak and the device falling.
Fix the cord in place with tape or the like so that it does not interfere with driving.
Do not block the camera lens, get dirt on it, or place a reflective object near it.
When LED traffic lights are recorded, video in which they appear to be flickering or flashing may
be recorded. JVCKENWOOD assumes no responsibility with regard to the distinguishing or
recording of traffic lights.
If coating is used on the windshield of the vehicle, recording quality may be affected.
There is no guarantee that the device can record video in all conditions.
When the device is dirty, wipe it with a dry silicone cloth or other soft cloth. If the device is very
dirty, remove the dirt with a cloth with neutral cleaner on it then wipe off the cleaner. Wiping the
device with a hard cloth or using a volatile substance such as thinner or alcohol may cause
scratches, deformation, deterioration or other damage.
When the lens is dirty, gently wipe it with a soft cloth dampened with water. Rubbing the lens
strongly with a dry cloth may cause scratches.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Precautions for installation
Precautions for use
Cleaning the device
If you notice a problem with the device, turn off the power of the device and then contact your
dealer or nearest JVCKENWOOD service center.