CI9532
5
PEARL
110436 REM IFU Ci9532_21L.indd 1 24.06.11 17:08
D
E I
G
H
L
A
B
C
K
F
A
PEARL
110436 REM IFU Ci9532_21L.indd 2 24.06.11 17:08
GBDNLFEIDKSFINPSKCZPL
HUN
RUTRROGRSLAE
HR/
SRB
Thank you for purchasing your new Remington® product.
Before use, please read the instructions carefully, and keep them in a safe place
for future reference.
PRODUCT FEATURES
A. Luxury Pearl Ceramic coating
B. 32mm large barrelled tong
C. Digital display 130°C -210°C
D. Ready to use in 30 seconds
E. On-off switch - Plug in the unit, press and hold the on-off switch for two seconds to
turn on hold again for two seconds to switch off.
F. Switch lock function :
Set the desired temperature by pressing +/- buttons and lock the switch settings by
pressing the ‘-‘ button for 2 seconds. A ‘lock’ symbol will appear on the display. This
will prevent accidentally changing the temperature settings whilst styling. To unlock
the switch settings, hold down the ‘-‘ button again for 2 seconds.
G. Cool tip
H. Heat protection stand
I. Automatic safety shut off – This unit will automatically switch itself off after 60
minutes and no button is pressed.
J. Protection glove – first line protection only (not shown) LCD display
K. Heat resistant pouch
L. 3m salon length swivel cord
M. Multi-voltage: For use at home or abroad: When used at 120V the heat up
times and temperatures may vary.
5 year guarantee
INSTRUCTIONS FOR USE
Before use make sure hair is clean, dry and tangle free.
Plug in the unit, press and hold the on-off switch for two seconds to switch on. Press again
for two seconds to switch off.
For extra protection and best results section the hair prior to styling and spray with heat
protection spray.
When styling use protection proof glove provided to avoid any accidental burns and avoid
touching the barrels.
1
ENGLISH
GB
110436 REM IFU Ci9532_21L.indd GB_1 24.06.11 17:08
ENGLISH
2
Take a section of hair – smaller section create tighter curls – larger sections create softer
waves
Hold the handle firmly in one hand the with the other wrap the section of hair around the
heated barrel
Hold in place for approximately 10 seconds for the curl to form then release
Repeat this around the head to create as many curls as desired
When finished press again for 2 seconds to turn off
Unplug from the mains when not in use.
IMPORTANT INSTRUCTIONS
Due to the extreme heat capabilities of this styler, extra care should be taken when using.
While heating, during use and cooling, place on a flat, smooth, heat-resistant surface. Only
hold unit at the end of the handle.
This is a high performance product, avoid frequent use to prevent damage to hair.
Please note regular use of styling products may deteriorate the coating.
Do not scratch the surface, as this will deteriorate the effectiveness of the coating.
CLEANING AND MAINTENANCE
Ensure the unit is unplugged and cool. Wipe clean any build up of styling products with a damp
cloth. Do not use an abrasive cleaning fluid to clean, as damage will occur.
SAFETY CAUTIONS
WARNING – FOR ADDITIONAL PROTECTION THE INSTALLATION
OF A RESIDUAL CURRENT DEVICE (RCD) WITH A RATED RESIDUAL
OPERATING CURRENT NOT EXCEEDING 30mA IS ADVISABLE. ASK AN
ELECTRICIAN FOR ADVICE.
WARNING – THIS APPLIANCE MUST NOT BE TAKEN INTO A BATHROOM,
IT SHOULD NOT BE USED NEAR BATHTUBS, SHOWERS, BASINS OR
OTHER VESSELS CONTAINING WATER OR OTHER LIQUIDS.
This product is not suitable for use in bath or shower.
THE STYLER SHOULD BE UNPLUGGED FROM MAINS SUPPLY WHEN NOT
IN USE.
110436 REM IFU Ci9532_21L.indd GB_2 24.06.11 17:08
ENGLISH
3
GBDNLFEIDKSFINPSKCZPL
HUN
RUTRROGRSLAE
HR/
SRB
GB
Do not leave the styler unattended when switched on.
Allow the styler to cool down before storage.
Do not immerse in water or other liquids.
Do not place styler on soft material e.g. carpet, bedding, towels, rugs etc.
Always ensure the voltage to be used corresponds to the voltage stated on the unit.
Keep this product out of reach of children. The use of this appliance by persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge
can give cause to hazards. Persons responsible for their safety should give explicit
instructions or supervise the use of the appliance.
Do not use any attachments with this styler, other than those supplied by Remington®.
Avoid allowing any part of the hot plates to contact the face, neck or scalp.
Do not wrap the cord around the unit. Check cord regularly for any sign of damage.
This product is not intended for commercial or salon use.
Damaged cords can be dangerous. If the supply cord of this unit becomes damaged,
discontinue use immediately and return the appliance to your nearest authorised
Remington® service dealer for repair or replacement in order to avoid a hazard.
Special tools are required for any examination, adjustment or repair. Unqualified repair
work could lead to hazardous conditions for the user.
We do not accept responsibility for damage to the product, persons or other items(s),
caused by misuse, abuse or non-compliance with these instructions.
WIRING INSTRUCTIONS UK Plugs Only
This product is fitted with a BS1363 plug fused at 5A. If the plug is unsuitable, it should be
disconnected and an appropriate plug fitted as detailed below. If it is necessary to replace
the plug fuse, use only fuses that are approved to BS1362, rated at 5A. If in doubt consult a
qualified electrician.
The wires in the mains lead are coloured in accordance with following code:
BLUE - NEUTRAL
BROWN - LIVE
As these colours may not correspond with the coloured markings sometimes used to
identify the terminals in a plug connect as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked
„N“ or coloured BLACK. The wire which is coloured BROWN must be connected to the
terminal which is marked „L“ or coloured RED. Never connect either of the wires to the
big EARTH terminal marked „E“ or coloured GREEN or GREEN AND YELLOW.
110436 REM IFU Ci9532_21L.indd GB_3 24.06.11 17:08