Instrukcja obsługi Pneumatyczny pistolet Humberg HM-259 do tynkowania ścian malowania natryskowy 6L

disposal instructions. Before use, please read and retain this document for future reference. The fol-

lowing warnings comply with legal requirements. Failure to observe these rules may result in serious

injury, equipment damage or voided warranty.

Use respiratory protection. When using

pneumatic spray guns, safety gear must

be worn.

to avoid eye injuries.

• Wear protective gloves! Protective gloves are necessary to ensure user safety, especially when

handling chemicals or sharp parts of the device.

• Wear anti-slip safety shoes! To protect your feet from injury, wear suitable safety footwear.

• Exercise caution around hot surfaces. Ensure the device is not used near flammable materials.

Parts of the device, such as hoses and nozzles, can heat up during operation and cause burns.

• Do not use a damaged device. If any damage is noticed, stop using the device immediately and

repair or replace the damaged part.

• Store the device safely. After use, always ensure the device is turned off, disconnected from the

power supply, and stored in a safe place, out of reach of children or unauthorized persons.

• Disposal recommendation. Used components such as filters, seals, as well as chemicals like

solvents and paints, should be disposed of at hazardous waste collection points. Paint containers

should be disposed of via selective waste collection.

• Warning of burn risk. During operation, do not touch hot parts, including hoses, nozzles, or other

surfaces that may heat up to high temperatures.

• Recommendation for proper use conditions. The gun should be stored in a dry, cool, and well-ven-

tilated area to prevent corrosion and damage to the mechanical and electrical parts of the device.

• Spray gun

• 4mm nozzle

1. Ensure that all components of the device are in good condition and show no signs of damage.

2. Connect the pneumatic gun to a compressed air source, ensuring that the pressure does not

exceed the maximum value specified in the manual.

3. Fill the gun's tank with the appropriate material, according to the paint manufacturer's recommen-

4. Wear the necessary personal protective equipment: protective mask, glasses, gloves, and safety

footwear.

1. Set the appropriate nozzle depending on the type of work (e.g., painting/plastering large surfaces

2. Empty the tank of any remaining material and rinse it with an appropriate solvent (according to the

instructions).

3. Clean the nozzle and other parts of the gun to prevent material from drying inside.

4. Store the device in a dry, cool place, away from moisture.