Znaleziono w kategoriach:
Długopisy 3d (3)
Wróć
- 1 -
ArtKid2 Play 3D
EN – USER MANUAL
- 2 -
BOX CONTENT
›3D pen
›USB-C charging cable
›12*3m PCL filament
›Templates
›User Manual
DESCRIPTION 1
2
3
4
5
6
7
8
1. Cartridge insertion hole
2. Charging cable connector connection socket
3. Battery indicator light
4. Heating indicator light
5. Power/speed button
6. Fill dispensing button
7. Fill dispensing stop button
8. Dispensing hole
CHARGING
The 3D pen must be fully charged before first use.
Plug one end of the charging cable into the socket on the top of the 3D pen. Plug the other end into the USB-A port of
your computer or a suitable network adapter (output voltage 5 V / 2 A). When the battery indicator light turns green,
the 3D pen is charged. Charging time usually takes 2 to 3 hours.
When the battery indicator light flashes red slowly during use, the 3D pen needs to be charged. When it flashes red
quickly, the 3D pen is turned off.
The 3D pen and charging cable may become warm during charging. This is a normal phenomenon.
Warning: Use only the supplied charging cable for charging.
OPERATION
Make sure the 3D pen is charged.
1. Press the power button for 3 seconds to turn on the 3D pen. The heating indicator light turns red and the hea-
ting process starts automatically. The heating time depends on the ambient temperature.
- 3 - - 4 -
2. When the heating indicator light turns green, the 3D pen is ready for use. Insert the cartridge into the hole on
the top of the 3D pen.
3. Press the refill dispensing button to automatically dispense refill from the dispensing hole for 15 seconds.
4. To stop dispensing heated refill, briefly press the refill stop dispensing button.
5. When you are not using the 3D pen, press the on/off button for 3 seconds.
Automatic shutdown
The 3D pen automatically turns off after 2 minutes of inactivity.
Notes:
Always wait for the 3D pen to warm up.
Use only the filaments that are supplied with the product, or which the manufacturer recommends.
Place the 3D pen on a heat-resistant mat.
The end of the filament must be cut straight.
Right Wrong Wrong
TROUBLESHOOTING
Problem Possible cause Solution
The indicator light does not light up. The 3D pen is discharged. Let the 3D pen charge.
Fault on the mainboard. Contact an authorized service
center.
The 3D pen does not dispense
a refill. The dispensing opening is blocked. Eliminate the cause of the blockage.
The 3D pen is not heated enough. Wait for the 3D pen to warm up.
The filament is inserted incorrectly. Remove the filament, cut it and
insert it again.
Fault on the mainboard. Contact an authorized service
center.
The filament is slipping. Turn off the 3D pen, let it cool down,
and clean the dispensing hole before
continuing.
The 3D pen does not heat up. The 3D pen is discharged. Let the 3D pen charge.
The 3D pen is not turned on. Move the switch to position 1 or 2.
Defect on the heating part. Contact an authorized service
center.
Note: If the problem persists, or not listed here, do not use the 3D pen and contact