MICRO SYSTEM
UX-E225B
INSTRUCTION MANUAL
NÁVOD K POUŽITÍ
INSTRUKCJA OBSŁUGI
NÁVOD NA POUŽITIE
HASZNÁLATI UTASÍTÁS
MANUAL DE INSTRUCȚIUNI
РЪКОВОДСТВО ЗА ЕКСПЛОАТАЦИЯ
EN
CZ
PL
SK
HU
RO
BG
EN
INTRODUCTION
• Thank you for buying our product.
• Please read through these operating instructions, so you will know how to operate your equipment
properly. After you finished reading the instructions manual, put it away in a safe place for future
reference.
WARNING
To prevent re or shock hazard, do not expose this appliance to rain or moisture. To avoid electrical
shock, do not open the cabinet; refer servicing to qualied personnel only.
CAUTION
Use of controls or adjustment or performance of procedures other than those specied herein may
result in hazardous radiation exposure.
DANGER
Invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam.
This Product is classied as a Class 1 LASER PRODUCT.
THE CLASS 1 LASER PRODUCT label is located on the rear exterior.
SAFETY
General
• Do not drop the device and do not expose it to liquid, moisture or humidity. These might lead to
damage to the device.
• If the device is moved from a cold environment into a warmer one, do let it adapt to the new
temperature before operate the device. Otherwise, it might lead to condensation and cause
malfunctions in the device.
• Do not use the device in the dust environment as dust can damage the interior electronic
components and lead to malfunctions in the device.
• Protect the device from strong vibrations and place it on stable surfaces.
• Do not attempt to disassembly the device.
• If the device is not using for a long period of time, disconnect it from the power supply by
unplugging the power plug. This is to avoid the risk of fire.
• The ventilation should not be impeded by covering the ventilation openings with items, such as
newspapers, table-cloths, curtains, etc.
• No naked flame sources, such as lighted candles, should be placed on the apparatus.
Battery handling and usage
• Only adults should handle battery. Do not allow a child to use this apparatus unless the battery
cover is securely attached.
• Remove batteries if exhausted or if they will not be used again for a long period. The incorrect use of
batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to
burst, therefore:
-Do not mix battery types, e.g. alkaline with zinc carbonate.
-When inserting new batteries, replace all batteries at the same time.
• Batteries contain chemical substances, so they should be disposed of properly.
EN
Risks associated with high volumes
Connect headphones with volume set low and increase it if required. Prolonged listening
through some headphones at high volume settings can result in hearing damage.
To prevent possible hearing damage, do not listen at high volume levels for long periods.
PRODUCT OVERVIEW AND CONTROL BUTTONS
NOTE: The USB port does not support charging external devices.
REMOTE CONTROL
To install the batteries
Lift o the battery compartment cover from the rear of the remote control. Insert 2 x 1,5V AAA size
batteries in accordance with the diagram in the battery compartment. Take care to observe the correct
polarity.
Remote control operation
To operate the device with the remote control, point the remote handset at the remote sensor on the
front panel and press the appropriate button on the remote handset. The remote works best within
a range of 6 ~ 7 meters from the front panel and on an angle of 30 degrees. Bright sunlight or room
light conditions can interfere with the remote control.
If the remote operation is unsatisfactory or stops working entirely, rst try replacing the remote
batteries, then try reducing the room lighting conditions.
1. IR receiver
2. LCD display
3. VOLUME knob / ENTER/NAVIGATE
4. OPEN button
5. /STANDBY button
6. MODE button
7. CLOCK SET MEM. button
8. MENU INFO button
9. BACK button
10. /PAIR button
11. /SCAN button
12. /TUNE- button
13. /TUNE+ button
14. Headphone output (3,5 mm)
15. USB port
16. Antenna
17. DC socket
18. AUX-IN input (3,5 mm)
19. Speaker output
EN
Remote control buttons
/ STAND-BY Press to turn ON/OFF.
/ SOURCE Press repeatedly to select the mode (FM/AUX/BT/USB/CD).
/ INTRO CD/USB: Random/Intro playback.
CD/USB: Repeat playback.
CLOCK SET Press to set time and date.
TIMER Press to set alarms.
MEMORY
FM: Press and hold to store a radio station to the presets.
Press to select a preset.
CD/USB: Programmed playback.
/ BT PAIR USB/CD: Stop playback.
BT: Press and hold to disconnect Bluetooth.
BT/USB/CD: Start/pause playback.
SCAN FM: Press to start a full scan.
MENU / INFO Press and hold to open the menu. Press to exit the menu.
FM: Press repeatedly to view information about the currently playing content.
+ / - Increase/decrease volume.
ST. / MONO FM: Press to select Mono/Stereo.
FOLDER+ FM: Press to select the next preset station.
USB/CD: Press to skip to the next folder.
FOLDER - FM: Press to select the previous preset station.
USB/CD: Press to skip to the previous folder.
/ TUNE FM: Press and hold to search for the previous station.
BT/USB/CD: Press to skip to the previous track.
/ TUNE FM: Press and hold to search for the next station.
BT/USB/CD: Press to skip to the next track.
ENTER Conrm entry.
0 ~ 9 Preset station selection.
EQUALIZER / X-BASS Press to switch between EQ modes.
Press and hold to enable/disable X-BASS.
Mute/Unmute.