Znaleziono w kategoriach:
Wentylatory (1)
Wróć
USER MANUAL
BENUTZERHANDBUCH
INSTRUKCJA OBSŁUGI
KB-7472
16” STAND FAN
STANDVENTILATOR 16”
WENTYLATOR
WOLNOSTOJĄCY
40 CM
P.1
Dear Customer,
We congratulate you for having chosen our product. Please read the following information’s carefully before using the
appliance for the first time for your own safety and to ensure correct use.
Safety information
The appliance must only be used as described in the instructions for use. Use for any other
purpose is inadmissible! Any damage attributed to incorrect operation, improper use or
non-observance of the safety information will invalidate all liability and the warranty!
• Before connecting the appliance check that voltage indicated on the type plate corresponds to the mains voltage in
your home! Only connect the appliance to a.c. mains as specified on the rating plate!
• Do not use the fan with a damaged plug, power cord, housing, or after a function or if it has been dropped or
suffered any kind of damage.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory
or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the
appliance.
Cleaning and user maintenance shall not be made by children unless they are older than 8 years and supervised.
Keep the appliance and its cord out of reach of children less than 8 years.
• Ensure that the fan is switched off from the supply before removing the guard.
• Do not let the power cord over a sharp edge of a table or counter, or let it not come into contact with any hot surface
and protect it against pinch, where it can be damaged. Never place or wind the power cord around the device.
During the operation of the device the power cord may not come in contact with the running fan.
• Only operate the device with fully unwound power cord. Danger of overheating and fire!
• Always unplug the device after each use or before you clean it. Do not pull at the power cord to disconnect the plug.
•
The socket-outlet must be accessible at all times to enable the mains plug to be disconnected as quickly as possible!
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified
person in order to avoid a hazard. Improper repairs can expose the user to considerable danger!
• Always disconnect the fan when adjusting it or moving it from one location to another, when not in use or when you
clean the fan.
• Allow to pursue the device not unsupervised and do not leave the house or your home if you use the device.
• Do not cover the device.
• Never touch live parts! Danger to life!
• Never operate or touch the appliance with wet or moist hands or feet! Danger to life!
• Be sure fan is placed on an even, flat, stable and dry surface when operating to avoid overturning. Do not use the
fan on uneven surface.
•
Do not hang or mount the fan on a wall or ceiling. Do not place the appliance near curtain or plants or in their vicinity.
• Maintain a safety distance of at least 50 cm from device to other objects.
• Do not use the fan outdoors.
• Do not place fan or any parts of the fan near an open flame, heat registers, cooking or other heating appliances or
other products that produce heat. Keep away the fan from flammable objects.
•
Do not use the appliance in flammable atmospheres (e.g. in the vicinity of combustible gases or sprays)! Fire hazard!
• Do not use the appliance without fix assembled fan-grille! Risk of injury. The fan-grille must be securely closed
during operation.
• Never insert fingers, pencils or other objects through the grille when fan is in operating or disconnected. Do not
insert any foreign objects into the grille or in the appliance openings. Risk of injury (electric shock) and damage to
the appliance!
• Avoid contact with moving parts or running fan blades with any part of your body or your hair. Danger to injuries and
damages!
• This appliance may not be used in bathrooms, showers, wash bowl, swimming pool or immediate vicinity of water,
damp or other liquids etc. or where is a risk of immersion or splashing.
• Do not immerse unit, plug or cord in water or other liquids.
• The device is for household use only.
• The device is not for the commercial use.
• Do not operate the appliance with an extension-cord or an interposed time switch clock or with other means which
switch the device automatically on or off as this can cause overheating and fire.
•
Do not use this fan with any solid state speed control device to reduce the risk of electric shock, overheating and fire.
• Do not use fan in windows. Rain may create electrical hazard! Danger to life!
• Do not use the product while sleeping.
• Never place the device where it could be subject to direct sunlight or excessive dust.
P.2
• Never place the unit where it could be subject to mechanical vibration or shock or lack of ventilation.
• During assembling or dis-assembling the fan may not connect to the electric circuit. Connect to the mains supply
only after the fan has been fully and correct assembled.
• Do not place the power cord under the carpet or hang the carpet not over the power cord. The power cord should
not cross any passage of people or articles to avoid tripping hazard or damage of the device.
• Pay attention to the security of your children and keep away all packaging parts (plastic bag, cardboard, styropor
etc.) from them.
These instruction for use belong to the appliance and must be kept in a save place. When changing owners, this
instruction must be surrendered to the new owner.
Packing:
• After unpacking the appliance, check the same for transport damage and the contents for completeness! In the
event of damage or an incomplete delivery, contact your authorized retailer!
• Do not discard the original box! It can be use for storage and dispatch to avoid transport damage.
• Dispose of the packing material in a proper manner. Plastic bags should keep away from children!
Description :
1) Guard ornament
2) Front grille
3) Blade retaining knob
4) Fan blade
5) Grille retaining ring
6) Rear grille
7) Motor shaft / Motor front
8) Motor housing
9) Oscillating control knob
10) Motor housing assembly/
Tilt adjustment knob
11) Switch compartment
12) Height adjustment ring
13) Lower metal pipe incl. inner pipe
14) Base ornament
15) Feet
16) Fan control switches
17) Retaining screw
Assembly
Caution! The fan should always be switched off
and does not connected to the mains supply,
if you mounting the fan.
Columns assembly :
A) Direction of rotation
B) Height adjustment ring
C) Base ornament
D) Lower metal pipe incl. inner pipe
• Assembly the feet (F) across and place the lower metal pipe
(D) upon the feet and fix it with the 4 screws provided.
• Loosen and remove the height adjustment ring (B) and pull
the base ornament (C) over the lower metal pipe (D).
• Let the Base ornament (C) slide over the mounted feet.
• If the caps from the feet are not mounted, please attach them.
• Pull the inner pipe till the end out of the lower metal pipe (D)
and slide the height adjustment ring (B) over the inner pipe onto lower metal pipe and tighten.
E) 4 screws
F) Feet
G) Caps
P.3
Attention:
Height adjustment ring must be fully fastened before start the assembly of the motor section
to the stand.
Assembly of switch compartment, motor and grille :
• Unscrew the retaining screw(17) on the switch compartment (11) and attach the motor with switch compartment
(11) onto the upper (inner) pipe (13).
• Catch the retaining nut in the intended slot on the upper end of the inner pipe (13). Ensure the switch compartment
is pushed fully onto the upper (inner) pipe and secured with the screw provided.
Please assemble ahead as follows:
• Unscrew the blade retaining knob (3) from the motor shaft (7) by rotating it clockwise.
• Unscrew the grille retaining ring (5) by rotating it anti-clockwise.
• Position the rear grille (6) on the motor shaft/motor housing (7) and ensure that the locating pegs are engaged
correctly in the holes in the grille.
• Screw the rear grille with the grille retaining ring (5) by rotating clockwise and tighten firmly.
• Place the fan blade (4) onto the motor shaft (7), locating the slot at the back of the blade on the drive pin that
passes through the motor shaft (7).
• Screw the fan blade (4) with the blade retaining knob (3) counter clockwise.
• Un-screw the locking screw mounted on the grille. Mount front grill (2) onto the rear grille (6) with the small round
hole matched for passage of locking screw. Fix both grilles with the clips then use screw driver to tighten the locking
screw – s. Figures:
Operating Instruction:
Connect to the mains supply only after the fan has been fully and correct assembled!
• Place the fan on a stable, flat, dry surface and look for a firm and secure stand.
• Check the fan is switched off.
• Insert the plug of the fan into a suitable socket outlet. The fan is ready to operate.
• By pushing the fan control switch (16) you can choose the speed levels of the fan.
0 = OFF
1 = low speed
2 = medium speed
3 = high speed
Oscillation:
• When you push and pull the oscillating control knob (9) you can switch the oscillating function ON or OFF.
Adjustments:
Caution: The fan should always be switched off and disconnected from the mains supply
when making this adjustment:
• To adjust the air flow upward or mild downward, simply loosen the tilt adjustment knob and move to desired angle
then retighten the tilt adjustment knob.
• The height of the fan can be adjusted by loosening the height adjustment ring (12) carefully raising or lowering the
fan and firmly retightening the height adjustment ring.
Switch off the Fan:
• The fan is connected to the mains supply and ready to operate as long as it is plugged in.
• To completely switch off the fan, set the speed button to position „0“ (Off) and pull the power plug from the socket
outlet.
• Always disconnect the mains plug from the socket outlet when the fan is not in use.
Pay attention that all fan parts
are correct and firmly connected
with each other.
P.4
Cleaning:
• Clean the device regularly.
• Before cleaning, switch off the device and unplug the fan from the socket outlet. Never clean this appliance when it
is plugged in!
• Do not immerse the device, power cord, plug or parts of the fan in water or other liquid or pour water or other liquid
over the fan. Do not spray the fan with liquids! Do not allow any water or other liquid to enter the motor housing.
Danger to life!
• Take a soft dry cloth if you want to make the appliance free from dust and fluff.
• Keep the ventilation slots on the back of the motor housing free of dust and fluff.
• Do not use detergents, abrasive cleaning powder or polish of any part of the device, as these can damage the
surface finish.
• If you do not use the appliance any time you should safe the fan for exceeding dust and dirt.
Storage:
Please keep the original carton box of the appliance about to store the fan out of the season. Store the unit in a clean
and packaged status and stock the appliance on a cool and dry place.
Notes:
- This device is not suitable for industrial use.
- Never try to open or repair the device by yourself as this can lost the guarantee and could also result in damage to
property and injury to people. In case of repair please contact your service station. Repairs are performed only by
authorized specialist or through our customer service.
Technical details:
Rated voltage: 220-240V ~ 50Hz
Power: 50 W
Class of protection: II
Disposal
The symbol on the product or on its packaging indicates that this product may not be treated as household
waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and
electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential
negative consequences for the environment and human health, which could otherwise be caused by
inappropriate waste handling of this product. For more detailed information about recycling of this product, please
contact your local authority,your household waste disposal service or the shop where you purchased the product.
This symbol is only valid in the European Union.
Guarantee
If problems occur with the device never try to open or repair by yourself. Every intervention in the unit for the change
of original condition leads inevitably to the loss of the guarantee claim. Contact the retailer where you have
purchased the appliance. The guarantee for this device is based on the guarantee instructions.
Damages which occur to transport, overloading, natural erosion, non observance of the Mounting-/ User-instructions
or improper treatment will be excluded from the guarantee. Technical changes concerning the advancement are
reserve.
Operating Instruction:
Connect to the mains supply only after the fan has been fully and correct assembled!
• Place the fan on a stable, flat, dry surface and look for a firm and secure stand.
• Check the fan is switched off.
• Insert the plug of the fan into a suitable socket outlet. The fan is ready to operate.
• By pushing the fan control switch (16) you can choose the speed levels of the fan.
0 = OFF
1 = low speed
2 = medium speed
3 = high speed
Oscillation:
• When you push and pull the oscillating control knob (9) you can switch the oscillating function ON or OFF.
Adjustments:
Caution: The fan should always be switched off and disconnected from the mains supply
when making this adjustment:
• To adjust the air flow upward or mild downward, simply loosen the tilt adjustment knob and move to desired angle
then retighten the tilt adjustment knob.
• The height of the fan can be adjusted by loosening the height adjustment ring (12) carefully raising or lowering the
fan and firmly retightening the height adjustment ring.
Switch off the Fan:
• The fan is connected to the mains supply and ready to operate as long as it is plugged in.
• To completely switch off the fan, set the speed button to position „0“ (Off) and pull the power plug from the socket
outlet.
• Always disconnect the mains plug from the socket outlet when the fan is not in use.