XR1430
XR1450
XR1470
HyperFlex Aqua
2
e
f
j
g
i
m n
l
j
k
o
r
3
Thank you for buying your new Remington® product. Please read these instructions
carefully and keep them safe. Remove all packaging before use.
IMPORTANT SAFEGUARDS
• This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been supervised/instructed and
understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be done by children unless they are
older than 8 and supervised. Keep the appliance and cable out of reach of
children under 8 years.
• Always check the appliance before you use it. Do not use the appliance if it is
damaged, as this may cause injury.
• The adaptor contains a transformer. Do not cut off the adaptor to replace it
with another plug, as this causes a hazardous situation.
The shaver is suitable for cleaning under an open water tap.
Suitable for use in a bath or shower.
• WARNING: Detach the shaver from the charging adapter before cleaning it in
water.
• Do not use the product with a damaged cord. A replacement can be obtained
via our International Service Centres.
• This product should only be used with the charging adaptor supplied.
Always replace a damaged adaptor with one of the original
type.
• Do not use the shaver, charging adaptor, charging stand or any other part if it is
damaged, as this may cause injury.
• This appliance should never be left unattended when plugged into a power outlet,
except when charging.
• Keep the power plug and cord away from heated surfaces.
• Do not plug or unplug the appliance with wet hands.
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
NO
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
UA
AE
4
• Do not twist or kink the cable, or wrap it round the appliance.
• This appliance is not intended for commercial or salon use.
PARTS
1. On/o switch
2. Head and cutter assembly
3. Comfort Float cutters
4. Hairpocket
5. Charging indicator light and low battery
indicator (XR1430)
6. Fuel gauge (XR1450)
7. LED display (XR1470)
8. Pop-up trimmer
9. Trimmer release button
10. Charging pins
11. Charging stand
12. Adaptor (not shown)
13. Headguard (not shown)
14. Cleaning brush (not shown)
GETTING STARTED
It is recommended that you use your new shaver daily for up to four weeks to allow time for
your beard and skin to become accustomed to the new shaving system.
CHARGING STAND
• Rotate open the charge stand fully to stand rmly on a at surface while charging. For
travel you can fold the stand around the shaver.
CHARGING YOUR SHAVER
• Ensure the appliance is turned o.
• Connect the charging stand to the adaptor and then to the mains.
• Place the shaver in the charging stand.
• Charge for at least 24 hours when using for the rst time.
• Allow 90 minutes for a full charge (XR1450 and XR1470) and 4 hours for XR1430.
• The charging indicator light (XR1430), fuel gauge (XR1450) or LCD display(XR1470) will
indicate when the shaver is fully charged.
• XR1430: When charge is low, the top LED will illuminate a solid red light. When
charging the bottom LED will illuminate a solid green light. When fully charged both
LEDs will be o.
• XR1450: The fuel gauge will display the amount of charge left when the shaver is on.
When charging, the LEDs blink in a clockwise rotation. When fully charged all LEDs will
illuminate then turn o.
• XR1470: When charge is low ‘Lo’ will appear on the screen and will ash until the shaver
is plugged in to charge. When charging, the LEDs blink in a clockwise rotation. When
fully charged the indicator will ash 60 for 5 minutes and then the display will shut o.
• To preserve the life of your batteries, let them run out every 6 months then recharge
for 24 hours.
• The appliance adapts automatically to a mains voltage between 100V and 240V.
ENGLISH
5
ENGLISH
INSTRUCTIONS FOR USE
SHAVING
• Note: This shaver is for cordless use only.
• Make sure your shaver is properly charged.
• Switch the shaver on.
• Stretch the skin with your free hand so the hairs stand upright.
• Only apply light pressure on the shaving head while shaving (pressing too hard can
damage the heads and make them vulnerable to breakage).
• Use short, circular strokes.
SHAVING WITH SHAVING GEL
• Follow the same instructions as dry shaving if using shaving gel.
• CAUTION After use with shaving gel, please rinse the head and cutters under warm
water to clean away any excess gel and debris.
TRIMMING
• Push the trimmer button to release the detail trimmer.
• Hold the trimmer at a right angle to your skin.
• Place the trimmer at desired trim line for a quick, easy, professional trim.
• To retract the trimmer, push down until it locks into position.
TRAVEL LOCK FEATURE
• Model XR1470 is equipped with a Travel Lock feature, intended to prevent the shaver
from turning on and discharging accidentally while packed in luggage.
To Set the Travel Lock:
• Press and hold the on switch for 3 seconds. The shaver will turn on, then will shut o
after the 3 seconds. The LED display will ash ve times to indicate the lock is set.
• While the travel lock is set, if the on switch is pressed, the LED display will ash three
times to indicate the shaver is in travel lock mode.
To Unlock the Travel Lock:
• Press and hold the on switch for 3 seconds. The LED display will ash threetimes while
the button is being held and then the shaver will turn on.
TURBO FEATURE (XR1470 ONLY)
• The XR1470 comes with a Turbo feature to shave thick stubble. Press the on/o switch
once to operate the shaver at normal speed. Press the on/o switch a second time to
operate the shaver in Turbo mode. When the Turbo feature is activated the LED display
will cycle around.
• To deactivate press the on o switch once to turn the shaver o.
GB
DE
NL
FR
ES
IT
DK
SE
NO
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
UA
AE