I remington-europe.com
Style Series Aqua Foil Shaver
F6000
2
e
f
m
k
m
g
i
l
j
n
E
F
G
o
3
Thank you for buying your new Remington® product. Please read these instructions
carefully and keep them safe. Remove all packaging before use.
IMPORTANT SAFEGUARDS
• This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been supervised/instructed and
understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be done by children unless they are
older than 8 and supervised. Keep the appliance and cable out of reach of
children under 8 years.
E Suitable for use in a bath or shower.
• Do not use the product with a damaged cord.
• The battery in this device is not replaceable.
• Do not use the appliance if it is damaged or malfunctions.
• Do not use attachments other than those we supply.
• This appliance should never be left unattended when plugged into a power outlet,
except when charging.
• Keep the power plug and cord away from heated surfaces.
• Do not plug or unplug the appliance with wet hands.
• Do not twist or kink the cable, or wrap it round the appliance.
• This appliance is not intended for commercial or salon use.
PARTS
1. On/o switch
2. Foil screens
3. Cutter assembly
4. Charging indicator lights
5. Hairpocket
6. Power port
7. Pop-up trimmer
8. Head release buttons
9. Head lock button
10. Stubble head guard
Not shown:
• USB charging cable
• Cleaning brush
GB
DE
NL
FR
ES
IT
DK
SE
FI
NO
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
RS
UA
BG
AE
4
GETTING STARTED
CHARGING YOUR APPLIANCE
1. Ensure the product is switched o.
2. Connect the product to the USB cable and then to the USB end of the cable to a
powered USB port.
CHARGING INDICATOR LIGHTS
Charge Level Lights
Charging The lights will come on one after the other then go o in a
repeating pattern.
Fully Charged Both lights will come on for 5 minutes then go out.
Low charge/charging
required The bottom light will ash rapidly.
Battery capacity 60%
or higher Both lights will come on.
Battery capacity 60%
or lower The bottom light will come on.
• Run time from fully charged is up to 60 mins.
• Charge time from empty is 90 mins.
• Note: To preserve the life of your batteries, let them run out every 6 months then fully
charge.
INSTRUCTIONS FOR USE
It is recommended that you use your new shaver daily for up to two weeks to allow time for
your beard and skin to become accustomed to the new shaving system.
• Make sure your shaver is properly charged.
• Switch the shaver on by pressing the on/o switch.
SHAVING
• Stretch the skin with your free hand so the hairs stand upright.
• Hold the shaving head so that the foils touch your face.
• Use short linear strokes.
TRIMMING
• Slide up the trimmer release button to activate the trimmer.
• Hold the trimmer at a right angle to your skin.
ENGLISH
5
ENGLISH
• To retract the trimmer, push the top rear of the trimmer down until it locks under the
trimmer release button.
STUBBLE LOOK
Fit the stubble head guard to your shaver for a 3-day stubble look.
HEAD LOCK
Normally, the head pivots freely but its movement can be restricted by sliding the head lock
button to the locked Lposition.
TIPS FOR BEST RESULTS
• Always hold the shaver at right angles to the skin so that all foils are touching the skin
with equal pressure.
• Use moderate to slow stroking movements. The use of short linear motions in
stubborn areas may obtain a closer shave, especially along the neck and chin line.
• DO NOT press hard against the skin in order to avoid irritation and damage to the foil
heads.
CLEANING AND MAINTENANCE
• To ensure long lasting performance clean after each use.
• Ensure the appliance is switched o and unplugged from the mains.
• The easiest and most hygienic way to clean the appliance is by rinsing the appliance
head after use with warm water.
DRY CLEANING
• Press the head release buttons and and pull the head upwards (Fig E).
• Gently tap out the excess hair shavings and use a cleaning brush to clean out the hair
pocket if necessary (Fig F).
• Note: Do not use a brush to clean the shaving foils.
• Replace the head assembly.
WASHABLE CLEANING
• Press the head release buttons and and pull the head upwards (Fig E).
• Do not use the brush to clean the foils but blow the shavings out or rinse in running
water (Fig G).
• Use the cleaning brush to sweep any loose hairs from the cutter and trimmer. Rinse in
running water.
• Replace the head assembly.
• Lubricate the teeth of the trimmer every six weeks with a drop of sewing machine oil.
REPLACING THE FOILS AND CUTTERS
• To ensure continued high quality performance from your shaver, we recommend the
foils and cutters are replaced regularly.
GB
DE
NL
FR
ES
IT
DK
SE
FI
NO
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
RS
UA
BG
AE