I remington-europe.com
Omniblade
HG1000
g
h
C
e
h
A
h
B
h
D
f
3
Thank you for buying your new Remington® product. Please read these instructions
carefully and keep them safe. Remove all packaging before use.
IMPORTANT SAFEGUARDS
• This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been supervised/instructed and
understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be done by children unless they are
older than 8 and supervised. Keep the appliance and cable out of reach of
children under 8 years.
E Suitable for use in a bath or shower.
• Do not use attachments other than those we supply.
• Do not use the appliance if it is damaged or malfunctions.
• This appliance is not intended for commercial or salon use.
BATTERY SAFETY
• Used batteries must be removed from the appliance and disposed of at an appropriate
ocial recycling/collection point.
• Do not try to charge non-rechargeable batteries.
• Do not put in re or mutilate your batteries when disposing as they may burst and
release toxic materials.
• Remove batteries if the unit is not in use for long periods.
• Dierent types of batteries or new and used batteries are not to be mixed.
• Do not short circuit the battery contacts.
PARTS
1. On/o switch
2. Battery compartment cover
3. Stubble combs (1, 3, 5 mm)
Not shown:
• 2 x AAA batteries
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
NO
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
RS
UA
BG
AE
4
ENGLISH
GETTING STARTED
BATTERIES
• Your shaver requires 2 ‘AAA’ alkaline batteries (rst set included).
1. Rotate the on-o switch/battery compartment cover counterclockwise to the position
just to the right of the O marking (Fig A) to unlock the battery compartment.
2. Pull the battery compartment cover downwards (Fig. B).
3. Insert batteries so that the (+) and (-) marks on the batteries face the same marks in the
battery compartment.
4. Replace the on-o switch/battery compartment cover and twist it to the O position to
secure it.
INSTRUCTIONS FOR USE
Switch the product on by rotating the on-o switch/battery compartment cover clockwise
to the I mark.
Always comb your beard or moustache with a ne comb before you start trimming.
FITTING AND REMOVING STUBBLE GUIDE COMBS (FIG. C)
To Fit
• Hook the front of the comb over the blade.
• Press the back of the comb down until it clicks into place.
To Remove
• Lift the tab on the back of the comb upwards until it comes free from the blade.
TO TRIM THE BEARD
1. Select your desired trimming length comb. If you are trimming for the rst time start
with the maximum trimming length setting.
2. Turn the unit on.
3. Place the at top of the xed comb against the skin.
4. Slowly slide through the hair. Repeat from dierent directions as necessary.
5. If hair builds up in the trimmer comb during the trimming process, switch the unit o,
pull o the comb and brush the hair o.
TO GET A SHAVEN LOOK
To trim any length of beard or stubble hair for a clean, shaven look then follow the above
steps without a comb attached to the blade head.
Place the at top of the blade against the skin and slowly slide through the hair against the
direction of growth.
Shave in an upwards direction when shaving under the chin (Fig. D).
5
ENGLISH
TRIMMING AND EDGING
1. Hold the device with the back side of the blade facing you with no combs attached.
2. Start with the blades resting lightly against your skin, use motions towards edge of
beard line to trim to desired locations in facial area.
3. Shape as desired.
TRIMMING WITH SHAVING GEL
Follow the same instructions as dry shaving if using shaving gel.
Caution: After use with shaving gel, please rinse the blade under warm water to clean away
any excess gel and debris.
CARE FOR YOUR GROOMER
To ensure long lasting performance of the groomer, clean after each use.
The easiest and most hygienic way to clean the groomer is by detaching the head from the
groomer body and rinsing the head with warm water.
The head can be removed from the body for cleaning by rotating it as shown in Fig D and
lifting it o the body.
To keep the unit in optimal condition we recommend re-oiling the blades after cleaning.
Place a few drops of cutter or sewing machine oil onto the blades. Wipe o excess oil.
RECYCLING
WTo avoid environmental and health problems due to hazardous
substances, appliances and rechargeable and non-rechargeable
batteries marked with one of these symbols must not be disposed of
with unsorted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and
non-rechargeable batteries, at an appropriate ocial recycling/
collection point.
GB
DE
NL
FR
ES
IT
DK
SE
NO
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
RS
UA
BG
AE