Instrukcja obsługi Latarka czołowa ARMYTEK Wizard C2 Pro Nichia

2 ENG USER MANUAL

6 GER BENUTZERANLEITUNG

10 FRA MANUEL D’UTILISATEUR

14 RUS РУКОВОДСТВО ПОЛЬЗОВАТЕЛЯ

18 FIN KÄYTTÖOHJE

22 SWE ANVÄNDARMANUAL

26 NOR BRUKSANVISNING

30 POL INSTRUKCJA OBSŁUGI REV_00-0004

WIZARD C2

boxes. The flashlight is easily installed, removed and 180° rotatable in

the mount. Quick-release silicone ring provides additional fixation

2. Every Day Carry light: compact design, convenient side button,

special matt anti-abrasive finish without rough knurling. Durable nylon

holster, robust removable steel clip and strong built-in tail magnet

3. Sports flashlight: body made from durable and lightweight

aircraft-grade aluminium, improved shock resistance. New springs for

better battery and driver protection, constant light without flickering.

Multiple variants of installation, optional accessories for mounting on

sporting gear

• Convenient wide beam of fully upgraded optical system, steel bezel

and tempered glass with anti-reflective coating for protection of the

• Innovative technology allows using any standard 18650 Li-Ion

battery with 10A discharge current. Full protection against short

circuit even in case of contact between magnetic connector and metal

• Active real-time temperature control to prevent overheating above

+58 °C

• Total protection from water, dirt and dust in accordance with IP68

ENG USER MANUAL

Thank you for choosing the products of Armytek.

Please read this manual carefully before using the flashlight.

Flashlight, 18650 Li-Ion 3500 mAh battery, magnetic USB charger,

headmount, clip, nylon holster, 2 spare O-rings, user manual.

The producer reserves the right to change the package at his own

discretion without modifying this manual. Specifications are sub-

ject to change without notice.

Initial Service

TO SET/REPLACE BATTERY

the flashlight.

Charger not plugged in:

• Green — device is in waiting mode.

Charger plugged in:

• Green blinking — evaluation of battery voltage.

• Red blinking — unscrew the tailcap to 1/4 for charging.

• Orange blinking — USB power source voltage is too low for correct

continuation of charging or bad contact between charger and battery.

rent power source.

• Red — charging with rated charging current is going on.

• Orange — USB power source voltage is too low, charging current is

reduced.

• Green — charging is finished.

Operation

Before use: Tighten the tailcap as far as it can go.

In OFF state

Firefly1 cycling through Main modes starts after cycling through Firefly

modes. Release to select.

2 clicks: To turn on Turbo mode from any mode. The second double click

brings back last used mode.

To switch between types of operation unscrew the tailcap to 1/4 while

the flashlight is o, press the button and tighten the tailcap while

keeping the button pressed.

[1] – Firefly modes, [2] – Main modes, [3] – Turbo modes,

[4] – Strobe modes

1 click: To turn on the last used mode.

Press and hold: To turn on Firefly1 mode [Section 1]. Keeping button

Main1 - Main2 - Main3 - Turbo1.

1 click: To turn o the flashlight.

switch between chosen modes in [Section 1] and [Section 2].

3 clicks: To turn on Turbo mode [Section 3].

4 clicks: To turn on Strobe mode [Section 4].

Automemorizing. After switching o the last used mode is memorized

for quick access at next switching on.

Lock-out function. Unscrew the tailcap to 1/4 for protection from

accidental switching on. Multicolor indication will be turned o.

Safe high brightness modes. Turbo modes give maximum brightness

until the temperature of the flashlight and discharge current of the

battery exceed critical values.

tion. Under good cooling conditions, the flashlight delivers light without

stepping down.

The flashlight has a multicolor temperature, battery level and state

indication (indication by the color LED in the button), as well as a low

battery level indication by light (indication by the main LED of the

flashlight). The flashlight indication in ON state includes a multicolor

battery level and temperature indication, and low battery level indica-

tion by light. When the flashlight is in OFF state, there is a multicolor

the brightness begins to decrease in steps to ensure the safety of

the battery and the user. If the brightness of the mode (except Firefly

modes and Main1) drops below approximately 25% from the nominal

value, the main LED flashes 2 times. When the battery level becomes

critical, less than approximately 10%, the color LED flashes red 1 time

every second.

to the warning level, the color LED in the button flashes orange 3 times

every 2 seconds. At critical level the LED flashes red 3 times every

second. The brightness begins to decrease to a safe level.

The indication also helps to find the flashlight in the dark.

onds of operation) and in OFF state (by default).

To change the operating mode, unscrew the tailcap to 1/4 while the

flashlight is o, press the button and keeping the button pressed, tight-

will switch cyclically. The settings will be memorized even when the

battery is changed. Ultra-low current consumption allows multicolor

indication to work for a maximum period of time.

The flashlight can get hot in Turbo modes, Strobe2 and Strobe3 quickly

For storage or transportation of the flashlight in a pocket or a bag

tion from accidental switching on.

It is forbidden to charge the battery inside the flashlight when the

ambient temperature is below 0 °C.

was caused by improper use of the product.

Care and Storage

It is recommended to clean the threads and O-rings o dirt and old

water and dust cannot be provided by worn-out sealing. The fouling as

well as lack of grease cause fast wear-out of the threads and sealing

toothpick (do not use sharp metal objects as they can damage the

rings).

After cleaning, grease the threads and the sealing rings that have

In case of active operation and exploitation in dusty environments, it is

recommended to clean and grease the parts as often as the necessity

WE DO NOT RECOMMEND leaving power supplies (especially

non-rechargeable) inside the flashlight for a long storage period, as

they can leak for various reasons and damage the inner parts of the

flashlight. If you want to keep your flashlight in a stand-by state with

batteries in, previously install new and high-quality batteries, store

Armytek provides free warranty repairs for 10 years (excluding

batteries, chargers, mounts, holders, switches and connectors, which

have 2-year warranty) from the date of purchase if there is a document

and buttons, silicone installation rings and holders, clips, silicone grips,

holsters, lanyards, O-rings and pads, Velcro tapes. The warranty also

does not extend to damage during: