Znaleziono w kategoriach:
Strzyżarka MAESTRO MR-652C 3-12 mm Niebieski

Strzyżarka MAESTRO MR-652C 3-12 mm Niebieski

Wróć
Model/Модель: MR652C
Сerticated in Ukraine
Виріб сертифіковано в Україні
Owners manual. Hair clipper set
Bedienungsanleitung. Haarschneidemaschine mit Zubehörkit
Instrukcji obsługi. Zestaw do strzyżenia włosów
Manualul proprietarului. Set (masină) de frezat
Руководство по эксплуатации. Набір для стрижки волосся
Керівництво з експлуатації. Набор для стрижки волос
091
EN
DE
PL
UA
RU
RO
2 3
Pictures/ Bilder/Rysunki/ Figuri/ Рисунки/ Малюнки
Pictures/ Bilder/Rysunki/ Figuri/ Рисунки/ Малюнки 1
2
Dear customer, we thank you for purchase of goods
Functionality, design and conformity to the quality standards
guarantee to you reliability and convenience in use of this device.
Please read and comply with these original instructions prior to the
initial operation of your appliance and store them for later use of
subsequent owners.
This appliance is designed for domestic use only.
Under condition of observance of user regulations and
a special-purpose designation, a parts of appliance do not contain
unhealthy substances.
Technical specications
Model MR652C
Electrical supply:
Alternating current- AC;
Rated voltage 220-240V;
Rated frequency 50Hz;
Power consumption 15W
Protective class II
Protection class IPX0
EN
B
C
D
E
А
4 5
Description of the appliance
Picture1 (page 2)
A. Blades
B. Housing
C. Blade lever
D. On/Off Switch
E. Power cord
Accessories
F. Attachment Combs
G. Oil
H. Cleaning brush
Safety instructions
When using your appliance, basic safety precautions should
always be followed,including the following:
WARNING!
DO NOT use this appliance near water or bathtubs, basins or other
vessels.
NEVER immerse the appliance, cable or plug in any liquid.
DO NOT allow water and moisture on the electrical parts of the
device.
NEVER touch the appliance with wet or damp hands.
Otherwise, there is a risk to get an electric shock!
- DO NOT let children or untrained persons use the appliance
without supervision.
- DO NOT leave the appliance unnecessarily plugged in.
Disconnect the plug from the mains when the appliance is
not being used.
- DO NOT use the power cord or the appliance in order to pull the
plug out of the socket.
- DO NOT leave the appliance exposed to the weather (rain, sun,
etc.).
- DO NOT leave the appliance without supervision when it is
connected to the power supply.
- Close supervision is necessary when the appliance is used near
children.
- Always use the appliance on a dry, level surface.
- Always unplug from the plug socket when not in use and before
cleaning.
- Do not operate the appliance if damaged, after an appliance
malfunctions or it has been damaged in any manner, return to at
authorized service engineer for repair.
- In the interest of safety, regular periodic close checks should be
carried out on the supply cord to ensure no damage is evident.
Should there be any signs that the cord is damaged in the slightest
degree, the entire appliance should be returned be authorized
service engineer.
- Do not let the cord hang over the edge of a table or counter or
touch hot surfaces.
- This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
- Children should be supervised to ensure that they do not play with
the appliance.
EN
6 7
- Do not place or store appliance where it can fall or be pulled into a
bath or sink.
- Do not use while bathing or in a shower.
- Do not place the appliance on any surface while it is operating.
- Never drop or insert any object into any opening on this appliance
WARNING! Do not use this appliance with a damaged or broken
comb nor with teeth missing from the blades as injury may occur.
- Before use, make sure certain blades are oiled and aligned
properly.
- Do not cut wet hair, before cutting dry and comb hair.
- Do not cut hair when there are dermatitis.
- Do not use this appliance for grooming pets.
THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY. DO NOT
USE THE APPLIANCE FOR ANYTHING OTHER THAN INTENDED
USE.
- Do not use it for commercial purpose.
Actions in extreme situations
- If your device has fallen into water or water has penetrated it,
immediately disconnect it from the mains without contacting the
device itself or the water.
- If there appears smoke, sparkling, strong smell of burning
isolation, immediately stop using the device, disconnect the device
from the mains and apply to the nearest service center.
Operation
Before startup
- Remove all wrap materials and stickers
- Make sure that all the parts of appliance don’t have
damages.
Oil
- To maintain your clipper in peak condition, the blades should be
oiled every few haircuts.
- Do not use hair oil, grease oil mixed with kerosene or any solvent,
as the solvent will evaporate and leave the thick oil which may slow
down the blades motion.
- Add a few drops of oil to the blades, turn clipper on for a few
moments, turn off and unplug. Wipe off any excess oil.
Blade lever
-The lever is conveniently located near your thumb (if you’re right-
handed) so it can readily be adjusted while the clipper is in your
hand.
-The lever adds versatility to your clipper by allowing you to
gradually change the closeness of your cut without an attachment
comb.
-When the lever is in the uppermost position, the blades will give
you the closest cut and -leave the hair very short. Pushing the lever
downward gradually increases the cutting length. See Picture 2
(page 2).
-In its lowest position, the lever will leave the hair approximately the
same length as the #1 comb.
-The lever will also extend the use of your blades since a different
cutting edge is used in each setting. In addition, if extremely heavy
hair cutting has jammed the blades, it will help you remove hair that
has become wedged between the two blades without removing the
blades.
-While the clipper is running, rapidly move the lever from “close
EN
8 9
cut” to “longer cut“ a couple of times. Doing this each time after you
have nished using your clipper will help to keep the blades clear. If
your clipper stops cutting and this does not help, your cutting blades
are dulled. Replace them with new blades.
Preparation for use
- Remove all wrap materials and stickers
- Make sure that all the parts of appliance don’t have damages.
- Inspect the clipper, making sure that it is free of oil between the
cutting blade teeth and turn the unit on to distribute the oil and to
make sure it is running smoothly. Wipe off any excess oil. This
should be done before each use.
-While using the unit, untwist the cord from time to time to avoid
tangling.
- Seat the person so their head is approximately at your eye level.
This allow ease of visibility while cutting and a relaxed control of the
unit
- Before cutting always rst comb the hair so it is tangle free and as
it is naturally worn.
Reminders
- Cut the hair in a relaxed and slow manner. Use short strokes only
to work gradually over the entire head.
- Always take off a little hair at a time; you can always trim off
additional hair later.
- As you work, comb the hair frequently back into the style to which
you are cutting.
- When cutting with this hair clipper it is better to leave the hair dry,
not wet. With the hair dry, it is much easier to control the amount of
hair being cut.
Attachment Combs (see main diagram).
Each comb attachment is marked accordingly on its outside middle
surface.
- To attach a comb, hold it with its teeth, upward and slide it along
the clipper blade until the front of the comb rmly seats against the
clipper blade.
- To remove the comb, simple pull the comb upward and away from
the clipper blade.
For even cutting, allow the comb attachment/cutter to cut its way
through the hair. Do not force it through quickly. Also remember to
comb the hair frequently to remove trimmed hair and to check for
uneven strands.
Maintenance and care
WARNING!
Before cleaning the appliance in any way, make sure that the
appliance plug is not connected to the socket.
Never place it in water or any other liquid.
- The appliance must be cleaned after each use.
- Clean appliance with brush.
- Wipe the housing with a soft dry cloth.
EN
Attachment Comb leaves hair length mm (inch)
№1 3(1/8)
№2 6(1/4)
№3 9(3/8)
№4 12(1/2)

Najnowsze poradniki

Zobacz więcej
Jaki aparat do vlogowania

Jaki aparat do vlogowania wybrać?

do czego służy parownica

Do czego służy parownica do ubrań - jaką wybrać?

No Frost

Technologia No Frost – nowoczesne chłodzenie bez szronu

Borderlands 4 - Premiera gry przesunięta. Ale tym razem to dobra nowina dla graczy!

rodzaje obroży dla kota

Rodzaje i zastosowanie obroży dla kota

Gdzie ustawić kuwetę dla kota

Gdzie ustawić kuwetę dla kota?

co to jest magsafe?

Czym jest MagSafe? Poznaj technologię, która upraszcza życie

Kody do The Forest – przedmioty, mutanty, budowanie i wiele więcej

Zewnętrzna karta graficzna - sposób działania i zastosowanie

Ranking hulajnóg elektrycznych dla dzieci [TOP10]

telewizor w sypialni

Telewizor w sypialni - czym się kierować podczas wyboru?

jaki kolagen najlepszy

Kolagen od A do Z – wszystko, co musisz wiedzieć

zmywarka do zabudowy 45 ranking

Ranking zmywarek do zabudowy 45 cm [TOP10]

nebulizator dla dziecka ranking

Ranking inhalatorów dla dzieci [TOP10]

Kawa ziarnista 100% arabica – ranking 2025 [TOP10]

Sprawdź więcej poradników

Footer

Pobierz aplikację mobilną Media Expert

Pobierz z Google Play
Pobierz z App Store

Właściciel serwisu: TERG S.A. Ul. Za Dworcem 1D, 77-400 Złotów; Spółka wpisana do Krajowego Rejestru Sądowego w Sądzie Rejonowym w Poznań-Nowe Miasto i Wilda w Poznaniu, IX Wydział Gospodarczy Krajowego Rejestru Sądowego pod nr KRS 0000427063, Kapitał zakładowy: 41 287 500,00 zł; NIP 767-10-04-218, REGON 570217011; numer rejestrowy BDO: 000135672. Sprzedaż dla firm (B2B): dlabiznesu@me.pl INFOLINIA: 756 756 756